Unior 1702 Suspension Fork Seal Driver (32mm)

Unior 1702 Suspension Fork Seal Driver Description:

The Unior 1702 Suspension Fork Seal Driver was designed to make it easier to more precisely install the seals on your fork. This tool features a chamfered shaft that makes sliding the seal on and off of this tool much easier, reducing the chances of tearing the seal. The oversized flat top gives a large target for a soft mallet to drive the seal into the fork, and thanks to the design of the tool that uses forks bushings to help guide the tool in straight into the fork, each tap of the mallet will precisely set the seal into the fork with less chances of distorting that seal. Best part of all is that this tool was designed to be compatible with both flanged and flangeless fork seals, so there are less tools needed to service the forks you are working on.

Features:

• Reinforced plastic construction is durable and is safe to use with seals and the fork housing
• Designed to use the forks bushings as a guide to eliminate crooked seals during installation
• Flat top design with minimal chamfering of edges assist with driving seals straighter into the fork
• Sizes are laser etched into the finish for a more permanent identification of the tool size
• Compatible with flanged and flangeless seals
• Available in a wide range of sizes to fit the most common fork stanchion diameters on the market

This product was added to our catalog on August 27, 2024